EN User instructions CDI 2012 DISHWASHER
Congratulations! CUSTOMER SERVICE AND GUARANTEE Thank you for choosing a Candy appliance; quality dishwashers which guarantee high performance and reliability. Candy manufacture a vast range of domestic appliances: washing machines, washer/dryers, cookers, microwave ovens, ovens and hobs, refrigerators and freezers. Ask your dealer for the catalogue with the complete range of Candy products.
SAFETY INSTRUCTIONS WARNING ! Knives and other utensils with sharp points must be loaded in the basket with their points down or placed in a horizontal position. There are certain basic safety rules which are valid for any domestic appliance. Installation Daily use ■ Make sure that the plug fitted to the machine is compatible with the power supply socket.
Water connection ■ The hose can be hooked over the side of the sink, but it must not be immersed in water, in order to prevent water from being syphoned back to the machine when this is in operation (fig. 4Y). Connecting the outlet hose IMPORTANT The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused. 1 ■ The outlet hose should disharge into a standpipe, making sure that there are no kinks (fig. 4).
WATER SOFTENER UNIT If your water is at level 0, you need not use any regenerating salt, nor need you make any adjustment, as your water is soft. Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks. The higher the level of these minerals present in the water, the harder the water is.
Adjustment of the upper basket ■ Salad bowls and plastic bowls may also be loaded on the upper basket. It is advisable to block these in place so that the jets of water do not make them overturn. LOADING DISHES 1 Using the upper basket If 27 cm to 31 cm plates are normally used, load them onto the lower basket after the upper basket has been placed in its upper position and proceed as detailed below: 1. Pull out the upper basket; 2. Then grasp the basket from both sides and lift it upwards (fig. 1).
A standard daily load is represented in figs. 1, 2 and 3. 1 A C B Upper basket (fig. 1) A = soup plates B = dinner plates C = dessert plates D = saucers E = cups F = glasses E D F B A C G D H 3D F E F 4 1. Upper basket position: low 2. Normal load 3. Shine setting: 6 A G C 4. Amount of detergent: - 8 g for pre-wash; - 22 g for wash. 12 international place load (Ref. EN 50242) 5 G C E C H B C I D F F E B General programme comparison (Ref.
LOADING THE DETERGENT AND THE RINSE AID Half load wash upper basket 1 C D F G B I H E 2 1/2 mixed load (fig. 1) A = glasses B = cups C = soup plates D = dessert plates E = saucers F = saucepan G = Irying pan H = medium bowl I = small bowl A A C F D B H E I 1/2 load standard (fig.
■ the effectiveness of detergents containing the built in water softener/salt depends on the hardness of your water supply. Check that the hardness of your water supply is within the effective range given on the detergent packaging. Should this occur, we would recommend using traditional separate products – salt, detergent and rinse agent. This will ensure that the water softener in the dishwasher operates correctly.
PRATICAL HINTS How to make savings ■ If you want the dishwasher to give a complete wash, place the dishes in the dishwasher at the end of each meal and if necessary turn on the COLD RINSE cycle to soften the food remains and remove bigger particles of food from the new load of dishes. When the dishwasher is full start the complete wash cycle programme.
DESCRIPTION OF THE CONTROL PANEL PROGRAMME SELECTION AND SPECIAL FUNCTIONS Programme interruption Opening the door when a programme is running is not recommended especially during the main wash and final hot rinse phases. However, if the door is opened while a programme is running (for example, to add dishes) the machine stops automatically. Close the door, without pressing any buttons. The cycle will start from where it left off.
If there is any break in the power supply while the dishwasher is operating, a special memory stores the selected programme and, when the power is restored, it continues where it left off. "START DELAY" button The dishwasher start time can be set with this button, delaying the start by 3, 6 or 9 hours.
PROGRAMME GUIDE ••••• • ECO Energy Saving Programme suitable for normal soiled items. Using detergents with enzyme. Programme standardised to EN 50242. ••••• RAPID 32’ Quick wash for dishes which are to be washed immediately after the meal. Wash load of 4/6 persons. •••• COLD RINSE Short cold pre-wash for items that are stored in the dishwasher until you are ready to wash a full load.
IDENTIFYING MINOR FAULTS FAULT Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks: FAULT 1 - Machine completely dead 2 - Machine does not draw water 3 - Machine does not discharge water 4 - Machine discharges water continuously 5 - Spray arms are not heard to rotate 6 - On electronic appliances without a display: one or more LED flashing quickly. CAUSE See causes for no.
The manufacturer declines all responsibility in the event of any printing mistakes in this booklet. The manufacturer also reserves the right to make appropriate modifications to its products without changing the essential characteristics.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household waste.
