User Manual

9. Trucos para la solución de problemas
Antes de llamar al Servicio Técnico
Revise las tablas de las páginas siguientes ya que le pueden ahorrar una llamada al servicio técnico.
Problema
Posibles causas
Qué hacer
El lavavajillas
no arranca
El fusible está
fundido o ha saltado
el diferencial
Sustituya el fusible o reinicie el diferencial.
Quite todos los demás electrodomésticos que
utilice el mismo circuito que el lavavajillas
No está encendido
Asegúrese de que el lavavajillas está encendido
y la puerta bien cerrada.
Asegúrese de que le cable está bien enchufado al
enchufe
Problemas
técnicos
La presión del agua
es baja
Compruebe que el agua está conectada y el grifo
abierto
La puerta del
lavavajillas no está
bien cerrada
Asegúrese de que la puerta está bien cerrada.
El agua se
queda
atascada
dentro del
lavavajillas
Problema en la
manguera de desagüe
Compruebe la manguera de desagüe
Filtro atascado
Compruebe el filtro rugosos
(consulte la sección “Limpieza del Filtro”)
Fregadero atascado
Compruebe que el fregadero no estás atascado.
Si el problema es que el fregadero está atascado
puede que tenga que llamar a un fontanero en
vez de al servicio técnico del lavavajillas.
Problemas
generales
Tubo interior
manchado
Se ha utilizado
detergente con
colorante
Asegúrese de que el detergente no tiene
colorantes
Película
blanca dentro
de la
superficie
Minerales del agua
Para limpiar el interior utilice con guantes una
esponja con detergente para lavavajillas. Nunca
utilice otro limpiador que no sea detergente de
lavavajillas para evitar espuma.
Restos de
óxido en la
cubertería
Los elementos
afectados no son
resistentes a la
corrosión
No se ha puesto en
marcha programa
alguno cuando se
echó sal. Restos de
sal durante el ciclo de
lavado
Ponga siempre el programa de lavado rápido sin
batería en el lavavajillas y son la función Turbo
(si la tuviese) después de añadir la sal.
La tapa del
abrillantador no está
bien apretado.
Compruebe la tapadera. Asegúrese de que está
bien cerrada.
Ruidos
Ruido de
golpes dentro
del
lavavajillas
Un brazo del aspersor
está golpeando a
algún elemento
dentro del lavavajillas
Interrumpa el programa y vuelva a colocar bien
los platos que están obstruyendo el brazo del
aspersor.
Ruido de
traqueteo
dentro del
lavavajillas
Se ha caído algún
cacharro dentro del
lavavajillas
Detenga el programa y vuelva a colocar los
cacharros dentro del lavavajillas.
Ruido en las
tuberías
Puede deberse a la
instalación o al cruce
de tuberías.
No afecta al lavavajillas. En caso de duda llame
a un fontanero.
18
Fuse blown, or the
circuit breaker acted
Replace fuse or reset circuit breaker. Remove any other
applianc es sharing the same circuit with the dishwasher
Spilled rinse-aid
Always wipe up rinse-aid spills immediately.
Hard water minerals
The affected items are
not corrosion resistant.
The lid of the softer
is loose
Asp ayarm is
knocking against
an item in a basket
r
Items of crockery
are loose in the
wash cabinet
This may be caused
by on-site installation
or the cross-section of
the piping.
Aprogramme wasnot
run after dishwasher
salt was added.
Traces of salt have
gotten into the wash cycle.
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves.
Never use any o ther cleaner than dishwasher
detergent for the risk of foaming or suds .
Always run the quick wash programme .
without any croc kery in the dishwashe r and
without selecting the Turbo function (if present),
after adding dishwasher salt.
Ch eck the lip .Ensure the fix is fine.
Interrupt the programme, and rearrange the items
wh ich are obstructing the sp ay arm.r
Interrupt the programme,
and rearrange the items of crockery.
This has no influence on the dishwasher function.
if in doubt, contact a suitably qualified plumber.
Detergent with
colourant was used
Make sure that the detergent is the one without
colourant.
Improper detergent
Make su re the dishwasher is turned on and the door is
closed securely.
Check that the water supply is connected properly and
the water is turned on.
Make sure to close the door properly and latch it.
Make sure the power cord is properly plug ged into the
wall socket.
Power supply is not
turned on
Water pressure is low
Door of dishwasher
not properly closed.
Kink in drain hose
Filter clogged
Kitchen sink clogged
Check drain hose.
Check coarse filter
(see section titled )
the
"Cleaning The Filter "
Check the kitchen sink to make sure it is d raining well.
If the problem is the kitchen sink not draining ,you may
need a plumber rather than a serviceman for dishwashers.
Use only the special dishwasher detergent to avoid suds.
If this occurs, open the d is hwasher and let suds evaporate.
Add 1 gallon of cold water to the tub . Close and latch the
dishwasher, then select any cycle. Dishwasher will drain
out the water at the first step.Open the door after draining
is stop and check if the suds is disappeared.
Repeat if necessary.
19