User Manual

Before reversing the door ,the power must be shut off.
All parts removed must be saved to do the reinstallation of the door.
NOTE:
This wine cooler has the capability of either opening the door from the left
or right side. The unit is delivered to you with the door opening from the
left side. Should you desire to reverse the opening direction, please
follow these instructions.
Reversing the Door Swing of Your Wine Cooler
4
This wine cellar has been built with the door hinges on the right. If you wish
to change the opening direction, follow the instructions below:
2. Remove the screws (1) that hold the upper hinge (5) (right side) to the
frame. Take away the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the screws(8) that hold the lower hinge(2) and Make sure to
Remove the lower hinge(2).
5. Remove the hole cover plate(7) to the right side.
6.
Install the lower hinge (2) onto the left side of the lower frame with screws (8).
7. Set the door to its place making sure the door seat at the lower hinge(2).
8.While holding the door in the closed position secure the upper hinge (5) in the
top frame of left side with screws (1). Please remember that do not tighten
the two screws(1) until the top of the door is levelled with the counter top.
1. Remove the upper hinge cover(6) first
9. Install the upper hinge cover(6) on the upper hinge..
Door opening from left side
Door opening from right side