EN
Thank-you for choosing a Candy washing machine. We are confident it will loyally assist you in safely washing your clothes, even delicates, day after day. Environmental conditions This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used).
l This appliances is intended to be used in household and similar applications such as: - Staff kitchen areas in shops, offices and other working environments; - Farm houses; - By clients in hotels, motels and other residential type environments; - Bed and breakfast type environments. A different use of this appliance from household environment or from typical housekeeping functions, as commercial use by expert or trained users, is excluded even in the above applications.
l After installation, the appliance l Do not expose the washing must be positioned so that the machine to rain, direct sunlight plug is accessible. or other weather elements. Protect from possible freezing. l The maximum load capacity of dry clothes depends on the l When moving, do not lift the model used (see control panel). washing machine by the knobs or detergent drawer; during l To consult the product technical transport, never rest the door on specification please refer to the the trolley.
l Release the power chord and drain hose from the securing clip at the rear of the machine. l Remove the 2 or 4 transportation screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. l If the washing machine is built-in, unscrew the 3 or 4 transportation screws (A) and remove the 3 or 4 flat washers, rubber bungs and plastic spacer tubes (B).
Instructions for mounting the furniture door l Position the template onto the reverse of the furniture door. It is possible to mount the hinges and closure magnet on the right or left-hand side depending on your requirements. Mark the screw hole positions, then drill out these positions. B C A l Fix the hinges in place with the 4 screws provided (A). l Fix the magnet (B) in place using screw (C).
the furniture door to the front of the washer using the hinges. Place the spacers under the hinges (I) and then fix in position with screw (H). EN l Mount H I We suggest mounting the furniture door so that it opens towards the left, which is the same direction as the porthole door. This will leave more space when you are loading washing into the appliance. l Slide the washer into an opening of the size indicated in the diagram opposite.
Hydraulic connections 3 l Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do not reuse old hose-sets). l Some models may include one or more of the following features: l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water tap and the red one to the hot water tap.
l Level the appliance using the feet as EN 8 illustrated in figure 8: a. turn the nut clockwise to release the screw; b. rotate the foot to raise or lower it until it touches to the floor; c. lock the foot, screwing in the nut, until it tightens against to the bottom of the washing machine. l Plug in the appliance. A B WARNING: contact the Customer Service Centre should the power cord need replacement.
Is a hot wash required? 3. PRACTICAL TIPS l Pretreat stains with stain remover or soak Load tips WARNING: when sorting laundry, make sure: - have eliminated metallic objects such as hair clips, pins, coins, from laundry; - to have buttoned pillow cases, closed zips, tied loose belts and long robe ribbons; - to have removed rollers, hooks or clips from curtains; - to have carefully read clothing washing labels; - to have removed any persistent stains using specific detergents.
finished, replace it turning it clockwise. The filter handle will be locked when it is not possible to turn any further and the handle is horizontal. Smearing a small amount of liquid soap on the filter seal will help refitting. To clean the washing machine exterior, use a damp cloth, avoiding abrasives, alcohol and/or solvents. To maintain a good wash performance we recommend that the soap drawer and pump filters are regularly cleaned.
5. QUICK USER GUIDE This washing machine automatically adjusts the level of the water to the type and quantity of washing. This system gives a reduction in energy consumption and a saving in washing times. 6. CONTROLS AND PROGRAMS A Program selection l Turn on the washing machine and select the required program. L l Adjust the washing temperature if necessary and press the required "option" buttons. I B l Press the START/PAUSE button to start washing.
Close the door BEFORE selecting the button START/PAUSE. l Press to start the selected cycle. When the START/PAUSE button has been pressed, the appliance can take few seconds before it starts working. PROGRAMME selector with OFF position ADD OR REMOVE ITEMS AFTER THE PROGRAMMES HAS STARTED (PAUSE) When the programme selector is turned the display lights up to show the settings for the programme selected.
l To delay the start use the following procedure: - AQUAPLUS l This option (available only in some - Select the required programme. - Press the delay start button once to activate it (h00 appears on the display) and then press it again to set a 1 hour delay (h01 appears on the display). The pre-set delay increases by 1 hour each time the button is pressed, until h24 appears on the display, at which point pressing the button again will reset the delay start to zero.
The machine is fitted with a special electronic device, which prevents the spin cycle should the load be unbalanced. This reduces the noise and vibration in the machine and so prolongs the life of your machine. 3 levels of wash intensity modifying the length of the programme, depending on how much the fabrics are soiled (can only be used on some programmes as shown in the table of programmes).
Digital Display 3) WASH TEMPERATURE LIGHTS The display’s indicator system allows you to be constantly informed about the status of the machine. This shows the washing temperature of the selected programme that can be changed (where allowed) by the relevant button. If you want carry out a cold wash all the indicators must be off.
l Through every wash phase "Kg Check" all the information about the functionality and the instructions for an easy configuration of the Wi-Fi, please refer to the "Download" section on http://simplyfiservice.candy-hoover.com.
Table of programmes 1) (MAX.) * PROGRAMME 2 1 (see control panel) (MAX.
Please read these notes: * Maximum load capacity of dry clothes, according to the model used (see control panel). ** STANDARD COTTON PROGRAMMES ACCORDING TO (EU) No 1015/2010 and No 1061/2010. ( ) Only with PREWASH option selected (programmes with PREWASH option available). COTTON PROGRAMME TEMPERATURE OF 60°C. WITH A 1) COTTON PROGRAMME TEMPERATURE OF 40°C.
Programmes selection To clean different types of fabrics and various levels of dirt, the washing machine has specific programs to meet every need of washing (see table of programmes). Mix Power System + The washing machine is equipped with an innovative pre-mix of detergent and water. A jet of water under high pressure sprays the mixture directly in the load.
Delicates This program has reduced periods of drum rotation during the cycle and is particularly suitable or washing delicate fabrics. The wash cycle and rinses are carried out with a high level of water to ensure the best performance. Drain + Spin The program completes the drain and a maximum spin. It is possible to delete or reduce the spin with the SPIN SPEED button. Mixed The washing and rinsing optimise the speed and rhythm of the drum action and water levels.
7. THROUBLESHOOTING AND WARRANTY If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. FOR SMART TOUCH MODELS The Candy simply-Fi app has a Smart Check-up function that allows you to confirm the functionality and status of the product at any time. To use the Candy simply-Fi app you will need an Android smartphone with NFC technology. More info can be found on the App.
Problem Possible causes and practical solutions The washing machine does not work / start The washing machine does not spin Make sure the product is plugged into a working supply socket. Make sure power is on. Make sure the wall socket is working, testing it with another appliance such as a lamp. The door may not be correctly closed: open and close it again. Check whether the required program was correctly selected and the start button pressed.
The use of ecological detergents without phosphates may cause the following effects: - cloudier rinse drain water: This effect is tied to the suspended zeolites which do not have negative effects on rinse efficiency. If the problem persists or if you suspect a malfunction, immediately contact an Authorised Customer Service Centre. It is always recommended to use original spare parts, that are available at our Authorised Customer Service Centres.
fkhldsk
fkhldsk
fkhldsk
- CBWM TH MPS (6÷9) - 16.
