Installation Guide

Page 3
SETTING PLUMBING CONNECTIONS
STEP ONE
STEP ONE
STEP TWO
Aqua Protect - SUPPLY TUBE WITH GUARD (fig 6)
should water leak from the primary internal tube “A”
the transparent containment sheath “B” will contain
water to permit the washing cycle to complete.
At the end of the cycle, contact the
Customer Service Centre to replace the supply tube.
A device located on the supply tube that stops water
flow if the tube deteriorates; in this case, a red mark will
appear in the window (A) & the tube must be replaced.
To unscrew the nut, press the one-way lock device (B)
Aqua Stop (fig 5):
Water mains connection settings with hot & cold water
for higher energy savings. Connect the grey tube to
the cold water tap & the red one to the hot water tap.
The machine can be connected to the cold water
tap only; in this case, some programs may start a few
minutes later.
Some models may include one or more of the
following features: HOT & COLD (fig 4)
Connect the water hose to the water supply tap (fig
3) only using the hose supplied with the appliance
(Do not reuse old hose-sets)
CONTACT CUSTOMER SERVICE SHOULD THE POWER
CABLE NEED REPLACEMENT
Plug in the appliance
C) Lock the foot, screwing in the nut, until it tightens
against to the bottom of the washing machine.
B) Rotate the foot to raise or lower it until it touches
to the floor;
A) Turn the nut clockwise to release the screw;
Level the appliance using the feet as illustrated in
(fig 8)
The washing machine should be installed in its final
position making sure the water fill hose is not kinked
or trapped. The corrugated drain hose should be
inserted nto suitable drain pipe of between 50cm &
85cm height above the floor using the curved drain
hose support. If an under sink connection is used the
drain hose must be routed above the sink overfill
opening to prevent back siphoning. Care must be
taken to avoid kinking or trapping in the train hose
(fig 7)
INSTALLATION GUIDE
Built-in washing machine