EN
Thank-you for choosing a Candy washing machine. We are confident it will loyally assist you in safely washing your clothes, even delicates, day after day. Environmental conditions This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used).
in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. 1. GENERAL SAFETY RULES l This appliances is intended to be used in household and similar applications such as: - Staff kitchen areas in shops, offices and other working environments; - Farm houses; - By clients in hotels, motels and other residential type environments; - Bed and breakfast type environments.
l To consult the product technical specification please refer to the manufacturer website. Electrical connections safety instructions WARNING: water may reach very high temperatures during the wash cycle. and l Do not expose the washing machine to rain, direct sunlight or other weather elements. Protect from possible freezing.
2. INSTALLATION l Remove the 2 or 4 transportation screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. l If the washing machine is built-in, unscrew the 3 or 4 transportation screws (A) and remove the 3 or 4 flat washers, rubber bungs and plastic spacer tubes (B).
Hydraulic connections 3 l Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do not reuse old hose-sets). l Some models may include one or more of the following features: l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water tap and the red one to the hot water tap.
l Level the appliance using the feet as 8 illustrated in figure 8: a. turn the nut clockwise to release the screw; b. rotate the foot to raise or lower it until it touches to the floor; c. lock the foot, screwing in the nut, until it tightens against to the bottom of the washing machine. l Plug in the appliance. A B WARNING: contact the Customer Service Centre should the power cord need replacement.
reduce the necessity of a hot wash programme. Save up to 50% energy by using a 60°C wash programme. 3. PRACTICAL TIPS Load tips WARNING: when sorting laundry, make sure: Before using a drying (WASHER-DRYERS) - have eliminated metallic objects such as hair clips, pins, coins, from laundry; l SAVE energy and time by selecting a programme high spin speed to reduce the water content in laundry before using a drying programme.
l Remove and clean the filter; when 4. MAINTENANCE AND CLEANING finished, replace it turning it clockwise. The filter handle will be locked when it is not possible to turn any further and the handle is horizontal. Smearing a small amount of liquid soap on the filter seal will help refitting. To clean the washing machine exterior, use a damp cloth, avoiding abrasives, alcohol and/or solvents. To maintain a good wash performance we recommend that the soap drawer and pump filters are regularly cleaned.
5. PORTHOLE EMERGENCY OPENING Should the porthole be locked due to power shortage or as a result of a fault, it can be opened according to the following emergency unlocking procedure: 1. Disconnect the machine from the power socket. 2. Ensure that the water level is below the porthole before opening it, to prevent any flooding. Otherwise, drain excess water through the drain tube and collect it in a bucket. 3. Take out the detergent compartment (fig. 1). 4.
6. WI-FI This appliance is equipped with Wi-Fi technology that allows you to control it remotely via App, thanks to Wi-Fi function. Get all the details of the Wi-Fi functions by browsing the App in DEMO mode. l Open the App, create the user profile and MACHINE ENROLLMENT (ON APP) enroll the appliance following the instructions on the device display or the "Quick Guide" attached on the machine. l Download the Candy simply-Fi App on your device.
7. QUICK USER GUIDE This washing machine automatically adjusts the level of the water to the type and quantity of washing. This system gives a reduction in energy consumption and a saving in washing times. 8. CONTROLS AND PROGRAMS Program selection l Turn on the appliance and select the required program. l Adjust the washing settings if necessary and select the required options.
SMART RING (ring for selecting PROGRAMMES/OPTIONS) WARNING: Do not touch the display while fitting the plug, because during the initial seconds, the machine performs a self-calibration that might be interrupted: if this occurs, the machine may not operate properly. In this case, remove the plug and repeat the operation. l After turning the appliance on, rotating the "SMART RING" the icons for the programmes will light up and the display will show the description and the relevant parameters.
After starting the washing machine you need to wait a few seconds before the appliance starts the programme. To prevent damage to the fabrics, it is not possible to increase the temperature above the maximum value set for each programme. CYCLE DURATION l When a programme is selected the display automatically shows the cycle duration, which can vary, depending on the options selected. l Once the programme has started you will be kept informed constantly of the time remaining to the end of the wash.
l Press START/PAUSE l Press START/PAUSE to start washing. to start the counting at the end of which the programme will automatically start. Setting AFTER having selected one or more options l The delay start can be cancelled, pressing l Press "ZOOM" to activate the function. the ON/OFF button for about 2 seconds, until the display switches off. The display shows the new information about the cycle.
Table of programmes 1) 2) (MAX.) 2 (see control panel) PROGRAMME COTTON** 3) 3) DELICATE PERFECT 20° 3) Standard* 1 3 8 3,5 9 4 10 4,5 90° ( ) 7 3 8 3,5 9 4 10 4,5 60° ( ) 4 2,5 4,5 2,5 5 3 40° ( ) 2 2 2 40° 1 3) 2 7 3) SYNTHETIC 3,5 2 AND COLOURED WOOL Standard* Standard* (MAX.
Please read these notes: 1) Maximum load capacity of dry clothes, according to the model used (see control panel). container, inserted into the compartment marked "2" in the detergent drawer, and set the special programme RINSE. When this phase has terminated, switch off the appliance, add the rest of the fabrics and proceed with a normal wash on the most suitable programme.
Programmes selection To clean different types of fabrics and various levels of dirt, the washing machine has specific programs to meet every need of washing (see table of programmes). COTTON STRONG Made to have a perfect washing. The final spin at maximum speed gives more efficient removal. COTTON This program is suitable to clean normally soiled cotton laundry and it is the most efficient program in terms of combined energy and water consumptions for washing cotton laundry.
9. THROUBLESHOOTING AND WARRANTY If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. ERROR CODE FORMAT l Models with a display: the error is shown by a number preceded by the letter “E” (example: E2 = Error 2). l Models without display: an error is shown by a sequence of flashes of every LED.
OTHER ANOMALIES Problem Possible causes and practical solutions The washing machine does not work / start The washing machine does not spin Make sure the product is plugged into a working supply socket. Make sure power is on. Make sure the wall socket is working, testing it with another appliance such as a lamp. The door may not be correctly closed: open and close it again. Check whether the required program was correctly selected and the start button pressed.
The use of ecological detergents without phosphates may cause the following effects: Warranty The product is guaranteed under the terms and conditions stated on the certificate included with the product. The warranty certificate must be duly filled in and stored, so as to be shown to the Authorised Customer Service Centre in case of need. Proof of purchase must be made available at the time of any warranty related repair.
WIRELESS PARAMETERS Parameter Specifications (Wi-Fi) Specifications (Bluetooth) Wireless Standard 802.11 b/g/n Bluetooth v4.2 Frequency range 2,412 GHz. - 2,484 GHz. 2,412 GHz. - 2,484 GHz. 802.11b, DSSS 1 Mbps = +19.5 dBm Basic data Rate: RF Transmit Power (Typ): +4 dBm 802.11b, CCK 11 Mbps = +18.5 dBm Max Trasmit Power 802.11g, OFDM 54 Mbps = +18.5 dBm 802.11n, MCS7 = +14 dBm 802.11b = 1024 bytes, -80 dBm 802.11g = 1024 bytes, Minimum Receiving Sensivity -70 dBm 802.
