EN
Thank you for choosing this product. We are proud to offer the ideal product for you and the best complete range of home appliances for your daily routine. Contents 1. GENERAL SAFETY RULES Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. 2. WATER CONNECTION 3. LOADING THE SALT 4. ADJUSTING THE UPPER BASKET (ONLY ON SOME MODELS) Only use the dish washer after carefully reading these instructions.
l This appliances is intended to be used in household and similar applications such as: − Staff kitchen areas in shops, offices and other working environments; − Farm houses; − By clients in hotels, motels and other residential type l Children should be supervised to ensure that they do not play environments; with the appliance. − Bed and breakfast type environments. l Children of aged 3 and under should be kept away unless A different use of this appliance continuously supervised.
l Do not leave the door open in l Before cleaning or maintaining a horizontal position, in order the dishwasher, unplug the to avoid potential dangers (e.g. appliance and turn off the tripping). water supply. l For further information on the product or to consult the technical l Do not pull on the power cord or appliance to unplug the data sheet, please refer to the machine. manufacturer's website.
there is a water softening Information for the test device installed in the home laboratories there is no need to add salt to the water softener fitted in the Please email the following address for the information required to dishwasher. conduct comparative tests and to l If the appliance breaks down or measure noise levels, according to stops working properly, switch it EN regulations: off, turn off the water supply and testinfo-dishwasher@candy.it do not tamper with it.
2. WATER CONNECTION l If the dishwasher is connected to new pipes The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused. or to pipes which have not been inuse for a long time run water through for a few minutes before connecting the inlet hose. In this way no deposits of sand or rust will clog up the water inflow filter. l The inlet and drain hoses can be directed to left or right.
A device located on the supply tube that stops water flow if the tube deteriorates; in this case, a red mark will appear in the window "A" and the tube must be replaced. To unscrew the nut, press the one-way lock device "B". All the dishwashers are equipped with an overflow safety device which, if water exceeds normal levels due to malfunctions, automatically blocks water flow and/or drains excess quantities. 4 SOME MODELS may include one or more of the following features: B l WATERBLOCK (fig.
Connecting the outlet hose l The outlet hose should disharge into a l The hose can be hooked over the side of standpipe, making sure that there are no kinks (fig. 6). the sink, but it must not be immersed in water, in order to prevent water from being syphoned back to the machine when this is in operation (fig. 6Y). l The standpipe must be at least 40 cm above floor level and it must have an internal diameter of at least 4 cm.
After loading the salt, YOU MUST run a complete washing cycle, or the PRE-WASH/COLD RINSE/REFRESH programme. (Fig. A "1") l The appearance of white stains on dishes is generally a warning sign that the salt container needs filling. l The salt dispenser has a capacity of between 1.5 and 1.8 kg and, for efficient use of the appliance, it should be refilled from time to time . l On the bottom of the machine there is a container for the salt for regenerating the softener.
4. ADJUSTING THE UPPER BASKET (ONLY ON SOME MODELS) Type "B": (ONLY MODELS WITH EASY CLICK): l If 29 cm to 32.5 cm plates are regularly Dishes that are greater than 20 cm* in diameter can no longer be loaded onto the upper basket, and the mobile supports cannot be used when the basket is in the upper position. 1. Remove the upper basket; 2. Hold the basket on both sides and lift it upwards (fig. 1).
Using the upper basket Upper basket (fig. 1) l The upper basket is provided with mobile racks hooked to the sides of the basket, which can be regulated into 4 positions. 1 l In the lowered position (A-A1) the racks may be used for such items as: tea and coffee cups, kitchen knives and ladles. Also glasses with stems may be safely hung on the ends of the racks. l In the upright position (B-B1) the racks allow you to load dinner plates and soup plates up to a maximum diameter of 19 cm.
l Place the cutlery in the plastic cutlery holder with the handles pointing upwards and place the cutlery holder on the lower basket (fig. 6) making sure that the cutlery does not get in the way of the rotating arms. Upper basket (fig. 5) 5 l The lower basket is fitted with a special adjustable central rack (fig. 3 and 4). This permits stable and optimum loading, even when the size and/or shape of the dishes is non-standard.
6. INFORMATION FOR TEST LABORATORIES Please ask information required for comparison testing and measuring noise levels, according to EN normative, to the following address: The lower basket has a safety-stop device, for its safe extraction, also especially useful with a full load. For loading salt, cleaning filter and for ordinary maintenance, the complete extraction of the basket is necessary. testinfo-dishwasher@candy.
7. LOADING THE DETERGENT (Fig. A "2") The detergent It is essential to use a detergent that is specifically designed for dishwashers either in powder, liquid,gel or tablet form. Unsuitable detergents (like those for washing up by hand) do not contain the proper ingredients for use in a dishwasher, and stop the dishwasher from working correctly. After pouring the detergent into the container, close the lid, firstly pushing (1) and then pressing on it (2) until you hear the click.
8. TYPES OF DETERGENT l read carefully and follow the manufacturer’s Detergent tablets l the effectiveness of detergents containing the built in water softener/salt depends on the hardness of your water supply. Check that the hardness of your water supply is within the effective range given on the detergent packaging.
9. LOADING THE RINSE AID (Fig. A "3") The rinse aid The rinse aid, which is automatically released during the last rinsing cycle, helps the dishes to dry quickly and prevents spots and stains forming. Filling the rinse aid container. The rinse aid container can be found to the left of the detergent container (fig. A "3"). To open the lid, push the reference mark and, in the same time, pull the tab of opening. It is always advisable to use rinse aid that is specifically designed for dishwasher.
10. CLEANING THE FILTERS EN (Fig. A "4") The filter system consists of: A. A central container that traps the larger particles; B. A micro filter, located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse; C. A flat gauze that continuously filters the wash water. l To achieve excellent results every time, the filters should be checked and cleaned after each wash. l To remove the filter unit, simply turn the handle anticlockwise (fig. 1).
l If you want the dishwasher to give a 11. PRACTICAL HINTS How to get really good wash results. l Before complete wash, place the dishes in the dishwasher at the end of each meal and if necessary turn on the COLD RINSE cycle to soften the food remains and remove bigger particles of food from the new load of dishes. When the dishwasher is full start the complete wash cycle programme.
Looking after your appliance correctly can extend its lifespan. Do not use tools that can deform the spray heads. Cleaning the appliance’s exterior 3) when you have finished, refit the rotor arms in the same position, remembering to re-align the arrow and screw into position. l Disconnect the machine from the power supply. l To clean the dishwasher outside, do not l Both the door lining and the tank lining use solvents (degreasing action) neither abrasives, but only a cloth soaked with water.
If the machine is not going to be used for some time, it is advisable to follow these rules: 1. do an empty wash with detergent in order to clean the machine of any deposits; 2. pull out the electric plug; 3. turn off the water tap; 20 4. fill the rinse aid container; 5. Ieave the door ajar; 6. keep the inside of the machine clean; 7. If the machine is left in places where the temperature is below 0°C any water left inside the pipes may freeze.
L "PROGRAMME SELECTION" lights M PROGRAMME GUIDE N SMART TOUCH AREA D "EXPRESS" option button” E "RESET" button for "SALT EMPTY" light F "START/RESET" button 21 Fuse / Power input / Supply voltage Water supply pressure (MPa) Capacity with pans and dishes Place settings (EN 50242) 120 Depth with door open (cm) 117 59,8x82x58 WITHOUT WORKTOP 13 8 people See rating plate Min. 0,08 – Max.
15. PROGRAMME SELECTION AND SPECIAL FEATURES Programme interruption Programme settings l Open the door and place the dirty dishes inside the appliance. l Press the "ON/OFF" button for about 2 seconds. l All the programme indicator lights will flash. Opening the door when a programme is running is not recommended especially during the main wash and final hot rinse phases. However, if the door is opened while a programme is running (for example, to add dishes) the machine stops automatically.
WARNING: Before starting a new programme, you should check that there is still detergent in the dispenser. If necessary, top up the dispenser. "NO SALT" indicator light This model is provided with an indicator light on the control panel which will light up when it is necessary to reload the salt container. The appearance of white stains on dishes is generally a warning sign that the salt container needs filling.
l Press the "DELAY START" button (each time the button is pressed the start will be delayed by 3, 6 or 9 hours respectively, and the corresponding time indicator light will switch on). l To start the countdown, press the "START" button (the set time indicator l light will start to flash). If a 9 hour delay is set, countdown will be displayed by the 6h indicator light after 3 hours and the 3h indicator light after 6 hours.
The last programme used can memorized by following the below: be 3. Release the button when the THIRD audible signal sounds (all the indicator lights will flash). The dishwasher must ALWAYS be off before start of this procedure 4. Press the same button again: the flashing indicator light (memorization off) will stop flashing and remain on (memorization on). 1.
16. SMART TOUCH HOW TO USE SMART TOUCH This appliance is equipped with Smart Touch technology that allows you to interact, via the App, with smartphones based on Android operating system and equipped with NFC (Near Field Communication) function. FIRST TIME - Machine registration l Download on your smartphone Candy simply-Fi App. the The Candy simply-Fi App is available for devices running both Android and iOS, both for tablets and for smartphones.
If you do not know the position of your NFC antenna, slightly move the smartphone in a circular motion over the Smart Touch logo until the App confirms the connection. In order for the data transfer to be successful, it is essential TO KEEP THE SMARTPHONE ON THE DASHBOARD DURING THESE THE FEW SECONDS OF THE PROCEDURE; a message on the device will inform about the correct outcome of the operation and advise you when it is possible to move the smartphone away.
17. PROGRAMME LEGEND Programme Description P1 Intensive Once a day - for heavily soiled pans and any other items that have been left all day for washing. P2 Universal Once a day - for normal soiled pans and any other items that have been left all day for washing. P3 Eco Programme for normally soiled tableware (the most efficient in terms of its combined energy and water consumption for that type of tableware). Programme standardised to EN 50242.
Detergent for soaking (Prewash) "IMPULSE" programmes Temperature of wash (°C) Average time of wash ¹ (min.
18. WATER SOFTENER UNIT Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks. The higher the level of these minerals present in the water, the harder the water is. The dishwasher is fitted with a water softener unit which, through the use of special regenerating salt, supplies softened water for washing the dishes. The degree of hardness of your water can be obtained from your water supply company.
If you believe the dishwasher is not working correctly, consult the quick guide provided below with some practical tips on how to fix the most common problems. If the malfunction continues or recurs, contact the Technical Assistance Centre. BUG REPORTS l Models with a display: errors are reported by a number preceded by the letter "E" (e.g. Error 2 = E2) and a short audio signal. l Models without a display: an error is shown by a sequence of flashes of every LED.
Only models without a display If malfunctions or faults occur when a programme is running, the indicator light that corresponds to the selected cycle will blink rapidly, and an intermittent audio signal will sound. In this case, turn the dishwasher off by pressing the "ON/OFF" button. After checking to make sure the water supply is open, that the drain pipe is not bent and that the siphon or filters are not clogged, set the selected program again.
5. Spray arms are not heard to rotate 6. On electronic appliances without a display: one or more indicator lights flashing quickly CAUSE Excessive amount of detergent Item prevents arms from rotating Filtering plate and filter very dirty Water supply tap turned off Switch off the appliance. Turn on the tap. Re-set the cycle.
N.B.: Should any of the above situations result in a bad wash performance or insufficient rinsing, remove dirt deposits from the dishes by hand since the final drying cycle hardens the dirt, making it difficult to remove with a subsequent wash. If the malfunction continues, contact the Technical Assistance Centre, quoting the model of the dishwasher. This is found on the plate on the upper section of the inside of the dishwasher door, or on the warranty.
l WEEE This appliance is marked a cording to the European directive 2012/19/EUon Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials.
- CF 6F52L - 20.09 - 41052155.A - IDM s.r.l.
