Use and Care Manual

If a minor problem develops, it usually
can be remedied quite easily when the
cause is found by using the check list
Below.
• Fault condition.
• Possible solution.
• Power cord not firmly plugged in.
• Push plug into receptacle all the way.
• No voltage at wall plug.
• Check fuse or breaker at electrical
panel.
• Replace fuse/reset circuit breaker.
• Thermal protector activated.
• Turn off the power switch and allow
the unit to cool for 30 minutes (this will
allow the thermal protector to reset).
Avoid conditions that will cause further
tripping of the thermal protector.
• Fault condition.
• Possible solution.
• Filter dirty.
• Clean filter (See section 4).
• Obstruction in hose or cleaning
tools.
• If the blockage is in the hose, insert a
long blunt item, such as a broom
handle, to clear the blockage.
• Check tools, wands, etc. For
blockages.
• Blockage in the hose can also cause
the thermal protector to activate. The
motor requires air flow when
operating.
• Dirt container full or mis-positioned.
• Check to see if the dirt container
needs to be emptied. (See section 4).
Check to see if the dirt container is
properly positioned on the seal and
the latches are secure.
If you are unable to resolve your
problem, contact your local Cana-Vac
dealer for further assistance.
Problem: Low Suction
Problem: Cleaner Won’t Run
If you have a
problem