User manual

TVS user manual Servicing and maintaining your TVS

7. Remove the TVS Saver.

8. Replace the cover and then tighten the four screws.

To restore your settings

1. Loosen the four screws in the TVS enclosure and then gently

remove the cover. Make sure not to disconnect the ribbon cable.

2. Insert the TVS Saver into the connector marked SAVER on the

inside top-left of the cover.

3. Press Program until (0Nf displays and then press Select.

The display shows 13, the first item in the Configuration menu.

4. Press Down until 20 displays and then press Select.

5. Press Up or Down to change the no to yes and then press Select.

The control reads the information from the TVS Saver. When

complete, the display shows done.

6. To return to the Configuration menu, press Back once. To return

to the Main menu, press Back twice. To return to the Main display,

press Back three times.

7. Remove the TVS Saver.

8. Replace the cover and then tighten the four screws.

Displaying the firmware version, parameter 23

Firmware is similar to operating system software for a computer. Firmware contains instructions

that tell the TVS how it operates. Just like computer operating systems (such as Windows™ XP)

have version numbers, the firmware has a version number.

If you need to contact Phason Customer Support about your TVS, you might need to provide them

with the firmware version of your control. For more information about technical support, read

Service and technical support at the front of the manual.

The TVS displays the firmware version as a number in the format #.##.

(0Nf