User manual

Chapter 5: Monitoring and maintaining your TVS Phason
44
To restore the factory defaults
1. Press Program until (0Nf displays and then press Select.
The display shows 13, the first item in the Configuration menu.
2. Press
Down until 21 displays and then press Select.
3. Press
Up or Down to change the no to yes and then press Select.
The control restores the factory defaults. When complete, the
display shows done.
4. To return to the Configuration menu, press Back once. To return
to the Main menu, press Back twice. To return to the Main display,
press Back three times.
Saving and restoring settings, parameters
19 and 20
The TVS Saver is an innovative and easy-to-use product that allows
you to store your TVS configuration and settings.
The TVS Saver stores a complete copy of all a TVS's configuration and
settings. You can restore the configuration and settings any time, or
even use them to set up new TVSs in seconds!
To save your settings
1. Loosen the four screws in the TVS enclosure and then gently
remove the cover. Make sure not to disconnect the ribbon cable.
2. Insert the TVS Saver into the connector marked SAVER on the
inside top-left of the cover.
3. Press
Program until (0Nf displays and then press Select.
The display shows 13, the first item in the Configuration menu.
4. Press Down until 19 displays and then press Select.
5. Press
Up or Down to change the no to yes and then press Select.
The control saves the information to the TVS Saver. When
complete, the display shows done.
6. To return to the Configuration menu, press Back once. To return
to the Main menu, press Back twice. To return to the Main display,
press Back three times.
(
0Nf
19
*
no
(
0Nf
21
*
no