User manual

Chapter 3: Configuring your TVS Phason
28
Testing the configuration
After configuring all the control elements (variable stages, relays, and so on), test your TVS to make
sure the configuration is correct. In other words, make sure what you think is connected to a
particular relay or stage is actually connected to that relay or stage.
You can test the configuration using the TVS's stage override mode. Stage override mode allows you
to operate the equipment, regardless of temperature or time. As you operate each piece of
equipment, visually check to see if that equipment is doing what you tell it.
For example, when you switch on stage 3 at the TVS, does the equipment you think is connected to
that relay switch on?
For more information about stage override mode, read Testing settings and equipment on page 40.