User manual

23
Chapter 3: Configuring your TVS
Chapter 3 explains how to configure your TVS. Configuring your TVS includes telling it which
equipment is connected to each terminal. Topics in chapter 3 include:
 What you need to know before configuring your TVS below
 Configuring the main control functions on page 24
 Configuring the stages on page 26
 Testing the configuration on page 28
What you need to know before configuring your
TVS
Configuring your TVS means telling it what equipment it will be controlling and how it will be
controlling that equipment. For example, your TVS has three relay stages. You need to tell the stages
if they will be controlling heating or cooling elements.
Before you begin configuring your TVS, make sure:
 It has power
 All equipment has been properly connected to the correct terminals.
 You know which equipment is connected to which relays and variable stages
This chapter does not explain set points, idle speeds, or other settings. For
information about those settings, read
Chapter 4: Programming the TVS on page 29.
 We recommend configuring all your control elements before programming the
settings (temperature set points, idle speeds, and so on). Use the
Appendix E:
Configuration worksheets
on page 57 to help you keep track of which equipment
is connected to which relays and variable stages.
 If you receive an error message during configuration, look it up in Appendix B:
Troubleshooting
on page 51 and then follow the instructions for correcting the
problem.
 Your TVS's built-in diagnostic tests are useful for testing your equipment after
installing and configuring it. For more information, read
Testing settings and
equipment
on page 40.