User manual

Chapter 2: Installing your TVS Phason
22
Finishing the installation
After installing and connecting equipment to your TVS, you are ready to finish the installation.
Before you start configuring your TVS, you need to verify the connections and close the TVS.
Verifying your connections
Make sure the configuration worksheets in Appendix E correspond to how the equipment is
connected to your TVS. It is very important that the connections and the worksheets are the same,
because the next step after closing the cover is to tell your TVS which equipment is connected to
each terminal.
Closing the cover
After you have finished connecting all equipment, wiring, and cables to your TVS, it is time to verify
the wires are connected properly and the close the cover.
1. Make sure all the wires are properly connected to the correct terminals.
2. Make sure the voltage selection switch is in the correct setting.
3. Make sure the display cable is properly connected. For more information, read TVS layout on
page 13.
4. Place the cover on the control.
5. Switch on the power to your TVS.
 When you switch on the power, the display should show ----, followed by the temperature.
 If the TVS display does not come on, go back to step 1.
 If the display shows an alarm message and/or the LED for Alarm is lit, press Select to clear
the message. For information about the alarm messages, read Alarm settings worksheet on
page 58.
6. Insert the four screws into the cover and then tighten them.
Do not over tighten the screws. Avoid using power screwdrivers or drills.