User manual

Chapter 2: Installing your TVS Phason
14
Mounting your TVS
1. Select a location for your TVS. Make sure you have enough cable and wire to reach all the
equipment (fans, heaters, and so on) that you want to control.
2. Remove the screws from the front cover and then gently lift it off.
3. Mount the enclosure to a wall using the four screws provided with the control. Insert the screws
into the large holes in each corner of the box and tighten.
Connecting equipment to your TVS
Follow all instructions when installing your TVS and connecting equipment to it.
Your TVS's test modes are useful for testing your equipment after installing and
configuring it. For more information, read
Testing settings and equipment on page
40.
Use the electrical knockouts for bringing wires or cables into or out of your TVS
enclosure. Do not make additional holes in the enclosure; this can damage the
watertight seal or control components and void the warranty.
Connecting single-stage heating or cooling elements
Heating or cooling elements include equipment such as electric heaters, furnaces, and single-speed
fans.
Refer to
Appendix D: Installation worksheet on page 56 and Appendix E:
Configuration worksheets
on page 57 when installing single-stage heating or
cooling elements.
The ratings of the equipment must not exceed the ratings of your TVS's relays.
Relay ratings: 6 A at 120/230 VAC general-purpose (resistive)
1/3 HP at 120 VAC, 1/2 HP at 230 VAC
360 W tungsten at 120 VAC