Programming instructions

60
A These are the timed event relays for the selected Power Block.
B These are the timed events (ON and OFF times) for the selected relay.
C This is a graph of timed events for the selected relay. The green sections represent when the
relay is on; red sections represent when the relay is off.
D This button opens the Timed events setup window, which is where you add and remove timed
events for the selected relay.
E This is where you add a timed event. To set the time, click and drag the number for hour or
minute up or down. You can also click the number and then press UP or DOWN on your
keyboard. To add the event to the list, click Add as….
F This button removes the selected event.
Use the
Timed events worksheet on page 89 when programming timed events.
 Each PBx Power Block can store up to 250 events, no matter how many relays
are configured.
 Timed events for PBx Power Blocks are stored on the Power Block and do not
rely on the software for timing. This means the timed events will function even if
there is no communication with the software.
 Timed events for PB-1 to PB-6 Power Blocks are stored in the software. This
means timed events will function only if there is communication with the
software.
To program timed events
1. In the main window, click Settings, and then Ventilation.
2. Below Your Power Blocks, select the Power Block you want to program and then click Edit
settings.
The Timed event settings window displays.
3. If the relay you want to program is not selected, below Timed event relays, select the relay you
want.
4. Click Edit events.
The Timed event setup window displays.