Programming instructions

Programming Power Block settings

The Temperature setbacks window is where you program the DIF and power save setbacks.

A This is a chart of the baseline set point and setbacks during the day. When you change the

setbacks, the chart adjusts automatically.

B This is where you enable or disable setbacks. When enabled, there is a checkmark in the box.

C This is the setback amount. To change the value, type a number in the box or click Up or Down.

D These are the start and stop times. To change a time, click and drag the number up or down.

You can also click the number and then press UP or DOWN on your keyboard.

Use the Master settings worksheet on page 82 when programming Power Block

settings.

 The following instructions use DIF as an example. The instructions for power

save are the same, but use the settings on the other side of the window.

 The setback must be enabled for you to change its settings.