Instructions / Assembly

Tel: [phone], Fax: [phone]
6. Position mounting bracket so
that the fixture will be hung
properly once it is mounted to the
ceiling. Tighten the screw to hold in
place.
7. Firmly attach the fixture
ground wire (bare copper) to the
mounting bracket with the ground
screw (by wrapping around the
ground screw) and then connect it
to the house supply ground wire
with a wire nut. Connect black wire
from fixture to black wire in outlet
box and connect the white wire
from fixture to white wire in
electrical box.
8. Once wire connections are
completed, carefully tuck wires and
wire nuts into the electrical box
making sure no bare wire (on the
black and white) is visible at the
wire nuts.
9. Position fixture over studs on
mounting bracket assembly.
Secure fixture in place with star
washers and cap nuts.
10. Remove spinner nut from
socket. Position shade on lamp and
secure with spinner nut.
11. Install proper bulb type and
wattage (not included).
Option#2- Hard-wire
1. Remove the back plate from the
fixture by unscrewing cap nuts and
star washers.
2. Use a pair of sharp scissors to
cut the cord. Strip 7mm from the 6”
cord.
3. Use the pliers to remove the
protective ring.
4. Fill the outlet hole by the hex
nut and screw.
5. Loosen “B”. Adjust stud to
desired length and lock in place with
“ B ”. Mount the mounting bracket to
electrical box using electrical box
screws. Make sure the studs on the
mounting bracket are facing out
from the electrical box.
Star
Washer
Stud
Cap
Nut
Fixture
Studs
Electrical
Box
Electrical Box Screws
(not included)
Mounting
Bracket
Mounting
Bracket
Screw
“B”
WhiteBlack
House supply
Ground wire
Fixture
Ground wire
Screw
Hex Nut
Pliers
Protective
ring
Back
plate
Star
Washer
Cap
Nut
Cord
6”
Shade
Spinner
Nut
Switch
Bulb
Type A Max 60W