Installation Sheet

INSTALLATION:
1. Screw the centre rod and
canopy to the fixture.
2. Loosen “B”. Adjust stud to
desired length and lock in place
with “B”.
3. Mount the mounting bracket
to electrical box using electrical
box screws (not included). Make
sure the studs on the mounting
bracket are facing out from the
electrical box.
4. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground screw
in the electrical box. Connect the
black wire (or wire with marking)
from the fixture to the black wire
in the electrical box and connect
the white wire from the fixture to
the white wire in the electrical
box.
5. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
electrical box making sure no bare
wire (on the black and white) is
visible at the wire nuts.
6. Position fixture over studs on
mounting bracket assembly.
Secure fixture in place with star
washers and cap nuts.
7. Install specified bulb type and
wattage (not included).
8. Attach the stem to the fixture.
Secure the glass in place using the
fibre washer, hex nut, decorative
cap and finial.
Tel: [phone], Fax: [phone]
ISF765A02
09/18
Star
Washer
Cap
Nut
Fixture
Fixture
Stud
“B”
Studs
Electrical Box Screws
(not included)
Electrical
Box
Mounting
Bracket
White
Black
House supply
Ground wire
Fixture
Ground wire
SAFETY PRECAUTIONS:
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4 TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A
CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
SEMI-FLUSH
MOUNT
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
Wiring supplies
as required by
local electrical
code
Center
Rod
Canopy
Stem
Bulb
Glass
Fiber
washer
Hex
nut
Decorative
cap
Finial