Installation Instructions

4. Hook the chain to the upper
loop. Feed the cord and ground
wire through the upper loop.
5. Connect the upper loop to
the canopy using a lockwasher
and hex nut.
6. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground
screw in the electrical outlet box.
Connect the black wire (or wire
marked “SPT-1”) from the fixture
to the black wire in the electrical
box and connect the white wire
(or the wire with ribbed side)
from the fixture to the white wire
in the electrical box.
7. Tuck electrical wires into
electrical box and position fixture
over studs on mounting bracket
assembly. Secure fixture in place
with star washer(s) and cap
nut(s).
8. Install specified bulb type
and wattage (not included).
9. Attach the glass shade to
the fixture using the thumb
screws (tighten with fingers only).
Flush Mount
Suspended Mount
Lockwasher
Hex
Nut
Loop
Nipple
Canopy
Lockwasher
Hex Nut
Socket
Assembly
Socket
Assembly
Socket
Assembly
Loop
Upper Loop
Chain
Cord
Ground
Ground
Cord
INSTALLATION:
IPL454B01
09/16
PENDANT LIGHT
White
Black
House supply
Ground wire
Fixture
Ground
wire
SAFETY PRECAUTIONS:
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
Wiring supplies
as required by
local electrical
code
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A
CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
Tel: [phone], Fax: [phone]
Star
Washer
Cap
Nut
Bulb
Thumb
screw
Glass
“B”
Studs
Electrical Box Screws
(not included)
Electrical
Box
Mounting
Bracket
1. Loosen “B”. Adjust stud to
desired length and lock in place
with “B”.
2. Mount the mounting
bracket to electrical box using
electrical box screws (not
included). Make sure the studs
on the mounting bracket are
facing out from the electrical box.
3. Remove the loop from the
socket assembly.
4. Place the canopy over the
nipple on the socket assembly
and secure in place with a
lockwasher and hex nut. Proceed
to step #6.
3.
Hook the chain onto the loop
of the socket assembly. Feed the
cord and ground wire through
every other link in the chain.