Installation Instructions

4. Secure the canopy in place
and tighten with the star
washer and cap nut. (See Fig.4)
5. Remove spinner nut from
socket. Position glass on lamp
and secure with spinner nut.
(See Fig.5)
6. Install proper bulb type and
wattage.
1. Attach the mounting bracket
to the outlet box using electrical
box screws (not included) and flat
washers. Attach the nipple to the
mounting bracket and adjust until
it will clear the canopy when
assembled (Place the canopy over
the nipple and tighten the upper
connector onto the nipple until
snug. The upper connector should
hold the canopy snug to the
ceiling). Lock the nipple in the
correct position using the hex nut.
(See Fig.1)
2. Spread one end of chain open
and fasten the upper loop. Hang
the chain to the upper loop and
close the opening. Repeat the same
for another chain connection. Feed
the cord and ground wire through
the chain and the upper loop. (See
Fig.2)
3. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground screw
in the electrical outlet box.
Connect the black wire (or wire
marked “SPT-1”) from the fixture to
the black wire in the electrical box
and connect the white wire from
the fixture to the white wire in the
electrical box. (See Fig.3)
INSTALLATION:
Nipple
Hex nut
Outlet box
Outlet box screws
Mounting
bracket
Nipple
Glass
Fixture
socket
Spinner
nut
Star
Washer
Cap
Nut
SAFETY PRECAUTIONS:
C-17
09/11
CHANDELIER
QUESTIONS OR CONCERNS CONTACT CANARM AT:
1-800-265-1833 (English)
1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Wiring supplies
as required by
electrical code
Pliers Wrench
L
I
G
H
T
I
N
G
&
F
A
N
S
E
C
L
A
I
R
A
G
E
S
&
V
E
N
T
I
L
A
T
E
U
R
S
Fig. 1
Fig. 2
Fig. 4
Fig. 5
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
NOTE: Product May Not Look Exactly As Shown In Figures.
Fig. 3
Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: [phone], Fax: [phone]
White
Black
House supply
Ground wire
Fixture
Ground wire