Instructions / Assembly

5. Feed the power leads up through the base and bolt the base
to the anchor bolts using locking nuts, anchor bolt nuts and cap
nuts.
6. Feed the power supply through the posts and connectors as
shown. Feed power supply through the cable tie. Tighten the cable
tie so that the power supply tightens against the bar.
7. Connect the power supply to the head assembly. Attach the
black wire to the black wires. Attach the white wire to the white
wires. Ground wire from power supply should be attached to
ground wire from bar inside the head assembly.
8. Once connections of wires are completed, carefully tuck wires
and wire nuts into the center post. Making sure no bare wire (on
the black and white) is visible at the wire nuts.
9. Screw the upper post into the head assembly (be careful not
to twist the wires).
10. Screw the connectors and remaining posts into the upper
post as shown.
11. Set the assembled pieces (lower post, middle post, upper
post & head assembly) onto the base by tightening the 3 hexagon
screws with the allen key (not provided).
12. Install the proper bulb type and wattage (not included).
Tel: [phone], Fax: [phone]
Base Plate
Anchor Bolt
Anchor Bolt Nut
Locking Nut
Base
Power
Cap Nut
Lower
Post
Upper
Post
Middle
Post
White
Black
Ground
Connector
Connector
Hexagon
Screw
Anchor Bolt Nuts
Allen key
Bulb
Bar
Ground
Head Assembly
Upper
Post
Power
Supply
Cable tie