Installation Instructions

Step 3

Step 5 Step 6

Step 4

Screw (A)

Plastic

bushing

Knob

Insert the 4 plastic bushings as shown and

secure the plastic bushings by the screws (B).

Rubber

cube

Tighten the screw (A) with the rubber cube to hold the

glass in place as shown.

Repeat steps for the other long glass and short glass.

Step 7

Spread one end of chain open and fasten the upper loop.

Hang the chain to the upper loop and close the opening.

Repeat the same for another chain connection. Feed the

cord and ground wire through the chain and the upper loop.

Nipple

Hex nut

Electrical box

screws

(not included)

Mounting

bracket

Attach the mounting bracket to the electrical box using

electrical box screws (not included). Attach the nipple to

the mounting bracket and adjust until it will clear the canopy

when assembled (Place the canopy over the nipple and

tighten the upper connector onto the nipple until snug.

The upper connector should hold the canopy snug to the

ceiling). Lock the nipple in the correct position using the

hex nut.

Screw (B)

Tighten the loops to the stems on the fixture.

Retighten the 4 screws in step 1 to install the top cover.

Loop

Screw (A) x 4pcs

Screw (B)x 4pcs