Installation Instructions

ManualsBrandsCanarm ManualsIndoor LightingLtd. Kellen Brushed Nickel 4-Light Island Light

ICH678A04XX30

ICH678A05XX40

09/16

INSTALLATION:

CHANDELIER

Step 1

Step 2

Long glass

SAFETY PRECAUTIONS:

TOOLS AND MATERIALS REQUIRED:

Phillips

Screwdriver

Wire Cutters

Pliers Wrench

INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS

READ ALL INSTRUCTIONS

IMPORTANT SAFETY

INSTRUCTIONS

SAVE THESE INSTRUCTIONS

QUESTIONS OR CONCERNS CONTACT AT:

1-800-265-1833 (English) / 1-800-567-2513 (French)

Monday through Friday 8:00 AM to 5:00 PM E.S.T.

Wiring supplies

as required by

local electrical

code

1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.

2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE

BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE

HAZARDS INVOLVED.

3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND

WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.

4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A

CLEAN, SOFT CLOTH.

NOTE: Product may not look exactly as shown in figures.

Put the fixture in position as in figure 1.

Unscrew the 4 screws to remove the top cover.

Screw

Knob

Top cover

A. Insert long glass as shown.

Push upward the glass against the top of the frame.

B. Slightly release the glass to reach the bottom of the frame.

Ensure the glass is behind the knob.

Follow this process to insert the short glass.

Side View

Summary of content (3 pages)

PAGE 1
CHANDELIER ICH678A04XX30 ICH678A05XX40 09/16 QUESTIONS OR CONCERNS CONTACT AT: 1-800-265-1833 (English) / 1-800-567-2513 (French) Monday through Friday 8:00 AM to 5:00 PM E.S.T. TOOLS AND MATERIALS REQUIRED: INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS READ ALL INSTRUCTIONS ! IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS SAFETY PRECAUTIONS: Phillips Screwdriver Wire Cutters Pliers Wrench Wiring supplies as required by local electrical code 1.
PAGE 2
Step 3 Step 4 Screw (B)x 4pcs Screw (A) x 4pcs Screw (A) Screw (B) Plastic bushing Rubber cube Knob Tighten the screw (A) with the rubber cube to hold the glass in place as shown. Insert the 4 plastic bushings as shown and secure the plastic bushings by the screws (B). Repeat steps for the other long glass and short glass. Step 5 Step 6 Loop Spread one end of chain open and fasten the upper loop. Hang the chain to the upper loop and close the opening.
PAGE 3
Step 8 House supply ground wire Connect the ground wires (bare copper or green) from your fixture to the ground wire (bare copper or green) or ground screw in the electrical box. Connect the black wire from the fixture to the black wire in the electrical box and connect the white wire from the fixture to the white wire in the electrical box.