Installation Instructions

INSTALLATION:
CHANDELIER
QUESTIONS OR CONCERNS CONTACT CANARM AT:
1-800-265-1833 (English) 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
SAFETY PRECAUTIONS:
4. Feed power cords from the
electrical box through the centre hole
of the back cover. Align holes of back
cover over electrical box and secure
with electrical box screws (not
included).
NOTE: Make sure the back cover is
level before tightening the screws.
Position the fixture and add wood
screws (one on each side) for the
wooden studs or plastic wall anchor
and wood screws for dry wall.
5. Connect the ground wires (bare
copper or green) from your fixture to
the ground wire (bare copper or
green) or ground screw in the electri-
cal box. Connect the black wire (or
wire marked “SPT-1”) from the fixture
to the black wire in the electrical box
and connect the white wire from the
fixture to the white wire in the electri-
cal box.
6. Once wire connections are com-
pleted, carefully tuck wires and wire
nuts into the electrical box making
sure no bare wire (on the black and
white) is visible at the wire nuts. Install
the light fixture to the ceiling by
aligning the hole(s) in the fixture with
the studs on the mounting bracket.
Secure fixture in place with star
washer(s) and cap nut(s).
7. Install specified bulb type and
wattage (not included).
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
Wiring supplies
as required by
the Canadian
Electrical Code
and/or the
Quebec
Electrical code
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
L
I
G
H
T
I
N
G
&
F
A
N
S
E
C
L
A
I
R
A
G
E
S
&
V
E
N
T
I
L
A
T
E
U
R
S
ICH629A04
10/15
NOTE: Product may not look exactly as shown in figures.
White
Black
Electrical
Box
Star
Washer
Cap Nut
Stud
Wood screw
Back
Cover
House supply
Ground wire
Fixture
Ground wire
Ground
wire
Electrical
Box Screws
(not included)
Bulb
1. Position the shade in place.
2. Install the length of rod that is required by
threading wire through the rod and screwing it
to the fixture. Install swivel to the rod, ensuring
that the sleeve is at the swivel.
3. Tighten the hex nut and star washer to the
swivel arm on the canopy.
Hex Nut
Star Washer
Rod
Sleeve
Swivel
Shade
Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: [phone], Fax: [phone]