Installation Sheet

Tel: [phone], Fax: [phone]
B. INSTALLATION FOR SEMI FLUSH MOUNT
1. Remove the loop from the fixture.
2. Place the canopy over the nipple on the fixture and secure in place with the star
washer, ground wire and hex nut.
3. Mount the mounting bracket to electrical box using electrical box screws
(not included). Make sure the studs on the mounting bracket are facing out
from the electrical box.
4. Connect the ground wires (bare copper or green) from your fixture to the ground
wire (bare copper or green) or ground screw in the electrical box. Connect the black
wire (or wire marked “SPT-1”) from the fixture to the black wire in the electrical box and
connect the white wire (or the wire with ribbed side) from the fixture to the white wire
in the electrical box.
5. Once connections of wires are completed, carefully tuck wires and wire nuts into
the electrical box making sure no bare wire (on the black and white) is visible at the
wire nuts.
6. Position fixture over studs on mounting bracket assembly. Secure fixture in place
with star washers and cap nuts.
7. Hang the crystals.
8. Install specified bulb type and wattage (not included).
Loop
Fixture
Star
Washer
Hex
Nut
Star
Washer
Cap
Nut
Fixture
Stud
White
Black
House supply
Ground wire
Fixture
Ground wire
2 - 2
Ground
Wire
Electrical Box Screws
(not included)
Electrical
Box
Mounting
Bracket