Instructions / Assembly

pg. 9
Figure 16
Figure 17
NOTE: Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box. Turning power off using the fan switch
is not sufficient to prevent electric shock.
Step 1. Remove the 1 of 3 screws from the
switch housing and keep it for future use.
Loosen the other 2 screws (Do not remove)
(Fig. 16)
Step 2.Raise and hold the LED light kit
close to the switch housing and proceed to
do the wire connections. Connect the white
wire connectors from the light kit and fan,
follow the same procedure with the black
wire connectors.
Step 3. Tuck connections neatly into switch
housing, Place the light kit key holes over
the 2 screws previously loosened from the
switch housing, turn light kit until it locks in
place at the narrow section of the key holes.
Secure by tightening the 2 screws
previously loosened and the one previously
removed.
Raise the glass shade up against the LED
light kit and secure it to the fan by turning
the glass shade clockwise until snug. Do
not overtighten.(Fig. 17)
11. INSTALLING THE LED LIGHT KIT
12. INSTALLING THE GLASS SHADE
Switch housing
Connection plugs
LED light kit
Screws
LED light kit
Glass shade