Instructions / Assembly

Pg. #4
Pg. #9
INST
INST
ALLA
ALLA
TION
TION
NOTE: All set screws must be checked and
retightened where necessary, before and after
installation.
1
1
.
.
ATTACH THE FAN BLADES
- Attach the blades to the
fan motor assembly using
- Re-attach the cover to
the top housing.
- Remove the cover on
the top housing.
Blade Bracket Screw
Screw
Screw
Lock Washer
Metal Washer
Blade
Blade
Motor
Fig.2b
Fig.2a
Fig.2c
ENGAGE HEMISPHERE (Downrod Mount Only)
- Carefully rotate fan assembly until groove in hemisphere locks over tab of
canopy assembly.
NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket
faces towards the top of the slope. Depending on the slope, a longer
downrod may be required to prevent fan blades from hitting the ceiling.
WARNING: Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
Downrod
Hemisphere
Groove
Fig.8b
6.
(A)
(B)
(B)
Washers
(A)
Fig.8a
the Blade Bracket Screws,
Metal Washer and Lock
Washer. Slightly turn the
blade after installation and
repeat the same step for
the other blades.
- Remove light kit screws and washers.
- Connect polarized connectors of light kit to corresponding connectors
found in switch housing.
WARNING: BE SURE TO TURN OFF POWER
BEFORE INSTALLING
Kit
LIGHT KITS
DETACHABLE LIGHT KITS
for your model)
(Refer to one of the following light kits
7.
Red or Blue
Wires
WhiteWires
Blackor
Blue Wires
Light Kit
Screw
Light Kit
Fig.9a
Plastic Screw
Fig.9b
- Install the light kit to the fan motor assembly by tightening 3 screws.
- Connect polarized connectors of light kit to corresponding connectors
found in switch housing.
- Remove the 3 plastic screw from light kit.
- Install the glass panel on the light kit by tightening the 3 plastic screws.
- Screw the diffuser to the Light kit.
Glass Panel