Installation Sheet

Pg. #6
Pg. #7
MOUNTING FAN ASSEMBLY
- Place two screws and washers on mounting plate (marked B on Fig. 7a)
corresponding to slots in canopy. Screw in two turns.
- Position canopy against mounting plate aligning slots to screws (marked
B on
Fig. 7a) then turn to lock.
- Position and tighten the two screws and washers (marked A on Fig. 7a)
then tighten the two screws (marked B on Fig. 7a).
ENGAGE HEMISPHERE (Downrod Mount Only)
- Carefully rotate fan assembly until groove in hemisphere locks over tab of
canopy assembly.
4.
5.
NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket
faces towards the top of the slope. Depending on the slope, a longer
downrod may be required to prevent fan blades from hitting the ceiling.
WARNING: Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
ELECTRICAL HOOK UP (Continued)
CONNECTING BLACK, WHITE, AND (RED OR BLUE) WIRES
NOTE: Once wires are connected, carefully tuck wires and marettes into the
metal outlet box making sure that the wires are clear of the hemisphere
and downrod when positioned in mounting bracket
(Downrod Mount Only).
Red or Blue
Wire
Black Wire
White Wire
3.
B
Fig. 6
- Connect white wire from outlet box to white
wire from fan using marette (not supplied).
- Connect black wire from outlet box to black
wire from fan plus (red or blue wire) using
a marette.
NOTE: A r
ed or blue wire would be power
for a light kit if applicable.
CONNECTING THE (GREEN) GROUND WIRE
NOTE: Once ground wires are connected, carefully tuck wires and marette into the
metal outlet box making sure that the wires are clear of the hemisphere and
downrod when positioned in mounting bracket (Downrod Mount Only).
CAUTION
SEE SAFETY PRECAUTIONS ON
PG. #2 BEFORE WIRING
Green Wire - GROUND
Black Wire (Fan) - POWER
White Wire (Fan) - COMMON
Red or Blue Wire (Light Kit) - POWER
ELECTRICAL HOOK UP
- There are several different wiring combinations that can be used to
control your ceiling fan depending on your specific requirements.
3.
A
Groove
(A)
(B)
(B)
Washers
(A)
Fig.7b
Fig.7a
Downrod
Hemisphere
- Connect ground wire from outlet box
to green wire from mounting bracket
and downrod using a
(not supplied).
- Connect ground wire from outlet box
to green wire from mounting bracket
using a (not supplied).
DOWNROD MOUNT
FLUSH MOUNT
Fig.5
Fig.4
Marette
Marette
marette
marette