Installation Sheet

Pg. #8
Pg. #5
INSTALL MOUNTING BRACKET
- Install J-Hook through centre of outlet box and into the wooden joist.
- Secure mounting bracket and rubber gaskets to metal outlet box.
- Hang the safety cable onto the J-hook.
- Hang fan on temporary hook and install safety cable.
2.
WARNING: To Reduce The Risk Of Fire, Electric Shock, Or Personal
Injury, Mount To UL/CSA Listed Outlet Box Marked Acceptable for
Fan Support And Use Mounting Screws Provided With The Outlet Box.
MOUNT BLADE BRACKETS TO BLADES
Cast Blade Brackets
- Tack out hardware package.
- Place blade bracket screw through flat washer, fibre washer and blade.
- Align with corresponding hole in blade bracket.
- Repeat with (2) remaining screws and tighten.
MOUNTING BLADES TO MOTOR
- Tack out hardware containing motor screws, lock washers and gaskets.
- Place lock washers over motor screws, position motor screws in blade
brackets, place fibre bracket gaskets over screws
and secure to motor.
Make sure all screws are tightened securely.
6.
7.
Blade
Bracket
Fibre Washer
Flat Washer
Fig. 8a
Blade Bracket Screw
Hex Nut
Fig. 9b
Fig. 9a
Fig.3c
J-Hook
Ceiling
Wood Joist
Outlet Box
Rubber Gasket
Mounting Bracket
Outlet box
Screws
(not provided)
Canopy
Safety
Cable
Temporary
Hook
J- Hook
Safety
Cable
Fig.3a
Canopy
Fig.3b
Diagram Fig.3b is for Downrod Mount.
Diagram Fig.3c is for Flush Mount.