Installation Sheet

Pg. #4
NOTE:
All set screws must be checked and
retightened where necessary , before and after
installation.
MOUNTING OPTIONS
INST
INST
ALLA
ALLA
TION
TION
DOWNROD MOUNT
- Using a Phillips screwdriver loosen the two upper jam screws on the yoke.
- Position downrod inside canopy.
- Route wires exiting yoke on motor through ceiling canopy and downrod.
- Position downrod/canopy into yoke and align holes in yoke and downrod.
- Insert bolt through hole in yoke and downrod. Be careful not to damage
or cut the fan wires.
- Tighten flat washer, lock washer, and nut and bolt (not included on some
models ). Secure with cotter pin through hole in the end of the bolt.
- Secure downrod in position by tightening upper jam screws.
1.
A
FLUSH MOUNT
- Remove the yoke screws and lock washers which correspond to the holes
- Optional for some models: Remove rubber ring from canopy (see Fig. 2d)
in the canopy.
- Position canopy over the holes on motor and secure with the same screws
and lock washers removed in the previous step. Be sure to place the rubber
bushing between the canopy and the motor.
B
8.
Pg. #9
WARNING: Check all connections, set screws and screws are securely tightened
before the next step.
Fig.10
LIGHT KITS (Optional in some fans)
A
DETACHABLE LIGHT KITS
- Remove light kit screws and washers.
- Connect polarized connectors of light kit to corresponding connectors
found in switch housing.
WARNING: BE SURE TO TURN OFF POWER
BEFORE INSTALLING
- Carefully tuck electrical wires back into switch housing, align light kit with
switch housing and secure with three light kit screws and washers.
To clean the fixture, turn off the power, wait for it to cool, and wipe the fixture
with a clean, soft cloth.
Canopy
Rubber Ring
Motor
Canopy
Yoke Screws
& Washers
Rubber Bushing
Fig.2d
Fig.2f
Motor
Light Kit
Screw
Star
Washer
Light Kit
Bolt
Yoke
Jam
Screw
Bolt
Flat
Washer
Cotter Pin
Yoke
Jam
Screw
Cotter
Flat
Washer
Pin
Fig.2bFig.2a
CAUTION
Do not loosen two
lower jam screws
Fig.2c