Installation Sheet

Pg. #10

Pg. #3

ASSEMBLY DRAWING

A. Mounting Bracket

B. Canopy

C. Downrod Assembly

D. Yoke Cover

E. Fan revoC repp U

G. Fan Blade

Fan Motor Assembly

H. Light Kit

I. Fan Lower Cover

. J

Remote Controlol

For model Aria

For model Andi

Fig.1a Fig.1b

NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket

faces towards the top of the slope. Depending on the slope, a longer

downrod may be required to prevent fan blades from hitting the ceiling.

Downrod

Hemisphere

Groove

WARNING: Ensure that all connections, set screws and screws are securely tightened

before the next step.

To clean the fixture, turn off the power, wait for it to cool, and wipe the fixture

with a clean, soft cloth.

Fig.10a

Fig.10b

MOUNTING FAN ASSEMBLY

- Place two screws and washers on mounting plate (marked B on diagram)

which correspond with slots in canopy. Screw in two turns.

- Position canopy to mounting plate aligning slots to screws (marked B on

diagram) then turn to lock.

- Position and tighten the two screws and washers (marked A on diagram)

then tighten the two screws (marked B on diagram).

ENGAGE HEMISPHERE (Downrod Mount Only)

- Carefully rotate fan assembly until groove in hemisphere locks over tab of

canopy assembly.

WARNING: Failure to seat tab in groove could cause damage to

electrical wires and possible shock or fire hazard.

(A)

(B)

Washers

(A)