Installation Instructions
Pg. #6
Pg. #7
INSTALL MOUNTING BRACKET
- Install J-Hook through centre of outlet box and into the wooden joist.
- Secure mounting bracket and rubber gaskets to outlet box.
- Hang the safety cable onto the J-hook.
- Hang fan on temporary hook and install safety cable.
WARNING: To Reduce The Risk Of Fire, Electric Shock, Or Personal
Injury, Mount To UL/CSA Listed Outlet Box Marked Acceptable for
Fan Support And Use Mounting Screws Provided With The Outlet Box.
5.
MOUNTING
DOWNROD MOUNT
- Insert bolt through hole in shaft and downrod. Be careful not to
damage or cut the fan wires.
- Tighten flat washer and bolt. Secure with cotter pin through hole in the
end of the bolt.
- Secure downrod in position by tightening jam screws. Slide yoke cover
down so it is flush with the motor housing.
- Take out motor housing.
- cotter pin and bolt from yoke.
- Loosen jam screw in yoke until it is flush with the inside surface.
- Obtain downrod, canopy and yoke cover.
- Place downrod inside canopy and yoke cover.
-
Route
wires
exiting
motor
through
yoke
cover,
canopy
and downrod.
4
4
.
.
Remove
fan
Fig.6a
Fig.6b
Ceiling
Outlet box Screws
(not provided)
J-Hook
Safety
Cable
Canopy
J-Hook
Wood Joist
Outlet Box
Rubber Gasket
Mounting Bracket
DC1.5V/ AAA*2pcs, not included), use a ball pen
please make sure not learn in other receiver.
ELECTRICAL HOOK-UP
A
6.
6.
LEARNING PROCESS
-. After installing the unit and power on, open battery cover (with battery,
to press and hold the ”LEARN” key 1~3seconds.
FAN will be turn off and then FAN turn ON at
medium speed, which indicate that learning
process finished. Please note that must press
the “LEARNING KEY" within 30 seconds after
power on. If just replac batteries,no need to
re-learn.
-.Please note that the transmitter can learn in
multiple receiver, when doing learing process
LIGHT FUNCTION SELECT SWITCH
LIGHT FUNCTION
SELECT SWITCH
Fig.7
LEARN
O/ DIM
AAA DC 1 . 5 V
AAA DC 1 . 5 V
bulb is used, then slide switch to the " DIM" position.
-.If you install an energy savongs bulbs such as a
fluorescent in your ceiling fan, slide the function
switch to " O" position and if a regular incandescent
Motor
Bolt
Yoke
Jam
Screw
Jam
Screw
Downrod
Canopy
Yoke
Cover
Bolt
Flat
Washer
Cotter Pin
Yoke
Jam
Screw
Fig.5a
Fig.5b
Fig.5c
Fig.5d
Fig.5e
Cotter
Flat
Washer
Pin