Maintenance Manual

CANAM TECHNOLOGY, INC. (CTI)
MARK-IV VHF NARROWBAND SIGNAL BOOSTER
OPERATIONS & MAINTENANCE (O&M) MANUAL
Page 34 of 37
Rev0 May/2011
F.2.3 Filter Settings Page
In this page the user can configure the filters as follow:
The “Apply to all filters” section allows configuring all filters using the same
Rx Threshold, Hysteresis, Fine-Tune Output Level and Tx Enable / CTCSS
Tone Enable / AGC enable status.
Pressing the “Apply” button (it is enabled upon a setting change) the
values in the fields will be applied to all filters.
Figure 14 – Filter Settings page (1/2)
The user may define the settings for each filter window as is shown in
Figure 15.