User's Manual

CANAM TECHNOLOGY, INC. (CTI)
MARK-IV UHF NARROWBAND SIGNAL BOOSTER USER’S MANUAL
Page 9 of 12
Rev0 May/2011
B.2 Using and setting up D.U.T
1. Open a web browser and access the equipment by typing, in the
address bar, the IP address (http://192.168.100.80) assigned to the
equipment.
o Login with username = operator, password = operator.
o The Main Status page will be displayed if connection available.
2. Go to Filter Settings page to configure the center desired frequencies
following filters distribution in Table 3.
Table 3 – Frequency ranges for filters
Frequency Range (MHz)
Assigned Filter Number
Low-end: 450-470
1 and 2
Mid-range: 470-490
3 and 4
High-end: 490-512
5 and 6
For example, the current programmed frequencies are the shown in
Table 4.
Table 4 – Current programmed filter center frequencies
Filter Number
Frequency (MHz)
1
450.0000
2
450.2000
3
480.0000
4
480.5000
5
511.8000
6
512.0000
o Every frequency to be tested must be enabled. Check/uncheck
Tx Enable to enable/disable filters.
o Filters in different frequency range (according to Table 3) must
not be enabled at same time.
o Press “Apply” button to apply changes.