User's Manual

CANAM TECHNOLOGY, INC. (CTI)
MARK-IV UHF NARROWBAND SIGNAL BOOSTER USER’S MANUAL
Page 11 of 12
Rev0 May/2011
Section C. RF Connections
C.1 Connecting the RF Out Port
1. Use a coaxial cable to connect the test instrument to D.U.T. RF Tx
Output Port (refer to Item#7 in Figure 3).
C.2 Connecting the RF In Port
1. Adjust the RF Generator output power to -60 dBm.
2. Adjust the RF Generator frequency to match the frequencies that have
been programmed in Table 4.
3. Use a coaxial cable to connect the RF generator output to D.U.T.
Antenna Rx Input Port (refer to Item #6 in Figure 3).