Operation and Maintenance Manual

CANAM TECHNOLOGY, INC. (CTI)
MARK-IVD 800MHZ NARROWBAND SIGNAL BOOSTER M4DBDA8 O&M MANUAL
Page 42 of 46
Rev1 May/2015
F.2.4 FILTER SETTINGS PAGE
In this page the user can configure the filters as follow:
 The “Apply to all filters” section (Figure 13) allows configuring all filters per
bank using the same Rx Threshold, Hysteresis, Fine-Tune Output Level,
CTCSS Tone Enable and Tx/AGC enable status.
Pressing the “Apply” button (it is enabled upon a setting change) the
values in the fields will be applied to all filters.
Figure 13 – Filter Settings page (1/2)
 The user may define the settings for each filter window as is shown in
Figure 14.