Operation and Maintenance Manual

CANAM TECHNOLOGY, INC. (CTI)
MARK-IVD 800MHZ NARROWBAND SIGNAL BOOSTER M4DBDA8 O&M MANUAL
Page 41 of 46
Rev1 May/2015
Also, there two settings that can be controlled using software commands:
Enable Automatic Mute
upon Reflected Power
Alarm
Check-box to enable/disable automatic
MCPA mute upon excessive reflected power.
Enable Reflected Power
Alarm Status Latch
Check-box to enable/disable the alarm status
latch.
F.2.3.5 Updating operational settings
 Write down the desired value in corresponding field.
 Using the checkboxes click to check/un-check.
 Press enter or “Apply” button for the system to validate the data and
apply changes.
o If the value is not valid, an error message will be displayed (see
Figure 12) and the new value will be not accepted keeping the
previous value.
 The current state applied to system is saved to the controller’s internal
nonvolatile memory for effective recovery after a power loss or system
reset.
Figure 12 – Value is not into valid range error message