Operation and Maintenance Manual

CANAM TECHNOLOGY, INC. (CTI)
MARK-IVD 800MHZ NARROWBAND SIGNAL BOOSTER M4DBDA8 O&M MANUAL
Page 29 of 46
Rev1 May/2015
F.1.2 CONNECTING SYSTEM TO LOCAL AREA NETWORK
Use standard straight-thru cable for network switch/hub connection.
To connect system to LAN, it is necessary to know the subnet the PC
computer is currently plugged into.
If no network is available the user shall remain using the crossover
interconnection
Figure 8 – System connected into local area network.
The following steps are necessary to connect system to LAN:
1. Connect the radio system and the computer together by means of
ethernet switch.
2. The radio system has a default IP address similar to 192.168.100.75 (S.M.
255.255.255.0)
3. Configure the computer’s IP address within the same subnet as the
radio system, 192.168.100.X (for example 192.168.100.75, S.M =
255.255.255.0) as shown in previous section.
4. Open a web browser and access the equipment by typing, in the
address bar, the IP address of the radio equipment
(http://192.168.100.75).
5. Login with username = operator, password = operator