Operation and Maintenance Manual

CANAM TECHNOLOGY, INC. (CTI)
MARK-IVD 800MHZ NARROWBAND SIGNAL BOOSTER M4DBDA8 O&M MANUAL
Page 26 of 46
Rev1 May/2015
Section F. WEB-SERVER GRAPHICAL USER INTERFACE
F.1 FIRST-TIME START CONFIGURATION
The system can be connected directly to PC computer using an Ethernet
crossover cable or to LAN using a standard straight-thru cord when using a
network switch/hub connection.
Section F.1.1 shows how to interface a computer directly to the system using
a cross-over cable in case there is no network switch available.
Section F.1.2 shows how to interface the computer to the RF device by
means of a network Ethernet switch.
Before to access system built-in Web Server verify your web browser is
working with java script enabled.
These are some web links showing HOW-TO enable java script.
https://support.microsoft.com/en-us/gp/howtoscript
F.1.1 CONNECTING SYSTEM DIRECTLY TO PC COMPUTER
Use an Ethernet crossover CAT5 cable for direct connection to a PC
computer LAN port.
Figure 5 – System connected directly to PC computer.
 Connect the system to PC computer directly into the ECM LAN port.
 The equipment IP address (192.168.100.75) and Network Mask
(255.255.255.0) are shown in the LCD display.