Operation and Maintenance Manual

CANAM TECHNOLOGY, INC. (CTI)
MARK-IV VHF BROADBAND SIGNAL BOOSTER M4BBDAV O&M MANUAL
Page 34 of 39
Rev0 April/2015
Temperature (ºC)
MCPA heat-sink temperature.
The Status indicator will be green when the
temperature is within the operating levels, red
otherwise.
Automatic Level Control Meters and Status
Modules Summary
Indicator is Green if module is active with no alarms,
red otherwise.
Comm Status
Indicator is Green if Analog Interface Card
communication is working, red otherwise.
RF Output (dBm)
Composite Output Power. This is the multi-carriers
signal, used to drive the broadband output.
The Status indicator will be green if the power is
above the threshold, gray otherwise (no traffic).
Current Drain Idc
(mA)
Analog-Module DC Current Drain (mA).
The Status indicator will be green when the current is
above the threshold, red otherwise.
General Meters and Status
PSU 5V Idc (A)/
PSU 12V Idc (A)
5Vdc/12Vdc current meter. Indicator is green if
current is within the operating levels, red otherwise.
Fan 1/Fan 2/Fan 3/Fan 4
Indicator. Green if front fans are fully operational
as detected by the air flow sensors; red otherwise.
Both of them are shown as a status indicator LED 8
in shelf rear panel.