Operation and Maintenance Manual

CANAM TECHNOLOGY, INC. (CTI)
MARK-IV VHF BROADBAND SIGNAL BOOSTER M4BBDAV O&M MANUAL
Page 28 of 39
Rev0 April/2015
F.1.2 CONNECTING SYSTEM TO LOCAL AREA NETWORK
Use standard straight-thru cable for network switch/hub connection.
To connect system to LAN, it is necessary to know the subnet the PC
computer is currently plugged into.
If no network is available the user shall remain using the crossover
interconnection
Figure 8 – System connected into local area network.
The following steps are necessary to connect system to LAN:
1. Connect the radio system and the computer together by means of
ethernet switch.
2. The radio system has a default IP address (S.M. 255.255.255.0).
3. Configure the computer’s IP address within the same subnet as the
radio system, 192.168.100.X (for example 192.168.100.75, S.M =
255.255.255.0) as shown in previous section.
4. Open a web browser and access the equipment by typing, in the
address bar, the IP address of the radio equipment.
5. Login with username = operator, password = operator