Operation and Maintenance Manual

CANAM TECHNOLOGY, INC. (CTI)
MARK-IV VHF BROADBAND SIGNAL BOOSTER M4BBDAV O&M MANUAL
Page 22 of 39
Rev0 April/2015
Section E. INITIAL CONFIGURATION
Canam Technology’s Equipment is factory configured. All setup
and wiring is performed by Canam’s Personnel. There is no need to
disconnect the equipment unless the units should be serviced.
If any module should be disconnected, it should only be done by
qualified technical personnel.
The unit operates stand-alone and only requires initial configuration, by
means of the Web Server Interface (over its LAN Ethernet interface).
The following guidelines provide information on how to get started with the
unit.
 Make sure the power switch is OFF, and plug the AC power cord into
the IEC inlet receptacle.
 Provide a connection from the off-air antenna interface to Antenna Rx
Input.
 Provide a connection from the in-tunnel (in-building) antenna point-of-
interface to the DONOR/BASE T/R PORT and SERVICE/SIDE T/R PORT.
 The dry-contact alarms are available on a pluggable mini-terminal
block on the shelf’s rear panel DB-25 connector.
 Additional I/O signals are available on a 6-contacts pluggable terminal
block.
 The technician’s computer shall be networked with the device, by
means of an Ethernet switch/hub or a direct PC-to-device connection
using a crossover cable. The computer shall have a Mozilla’s Firefox
web-browser software installed, or similar.