User's Manual

MARK-IV BROADBAND AMPLIFIERS
User’s Manual
4 / 11
REV3 01/25/06
General Disclaimers
This manual is intended to be used with the MARK-IV Equipment only. It is not to be used
with any other equipment unless it is authorized by Canam Technology, Inc.
Canam Technology, Inc provide this document “as is” without any warranty of any kind.
This document may contain typographical errors and technical inaccuracies. Canam
Technology will not accept any liability from the use and misuse of this manual, the
information contained within, or the consequences of any actions resulting from the use
of this information.
The user can not make any modifications to the unit(s). Changes or modifications not
expressly approved by the party responsible for compliance voids the user’s authority to
operate the equipment.
Radio-Frequency Amplifiers such as the MARK-IV generate radio signals and, therefore,
electromagnetic fields. The technical personnel should have a complete understanding
of FCC CFR Title 47 sections 1.1307 and 1.1310. Recommendations are included in this
Manual, but they do not substitute the FCC guidelines.
This device may require the use of antennas for proper functioning, depending on the
application. The installation of the antennas should be performed by qualified technical
personnel. All antennas should be fixed mounted and physically secured to one
location. The people must be away from the antennas at least 1.0 meters to comply with
the RF Human Maximum Permissible Exposure limits, as long as the antenna system gain
is lower than 0 dBi. If greater gain is used the separation should be increased, please
refer to the FCC Rules.
If service should be performed on the antenna, please shut down the transmitter or lower
its power in order to comply with the maximum permissible exposure.