User's Manual

Canam Technology, Inc. (CTI)
MARK-IV CHANNELIZED (Class A Narrowband) SIGNAL BOOSTER WITH AUTOMATIC
OUTPUT LEVEL CONTROL M4-ChOLC
User’s Operations and Maintenance Manual (O&M)
3. Follow the installation instructions that appear on the screen.
After the application has been installed, it can be access by going to Start ► All Programs ►
CTI ► Serial. The application main window should appear as shown in
Figure 9.
Figure 9: M4-ChOLC Frequency Programming G.U.I. Application
The tab Port Selection shows the detected COM ports in the host computer. To choose the
desire output port, click on the corresponding icon.
The icon meanings are as follows:
This icon means that the port is available and it can be used to connect to the
M4-ChOLC.
This icon means that the port is being used by another application or service.
These ports are not available to connect to the M4-ChOLC.
This icon means that the communications port is a MODEM. This port cannot be
used to connect to the M4-ChOLC.
NOTE: In order to connect the host Computer with the M4-ChOLC, use the interface cable
provided by Canam Technology part number CT-M4-ChOLC-COMCABLE. Connect the PC
RS-232 Port to the M4-ChOLC COM IN port. Do not connect a telephone line to the
equipment, the port may get damaged.
Once the COM port is selected, the user can change the M4-ChOLC operating frequency.
By using the tab Communications, it is possible to program the module’s operating
frequency, as shown in
Figure 10.
MARK-IV CHANNELIZED Signal Booster module (M4-ChOLC) O&M Manual Page 14 of 20