Installation Guide

Item NO.:SA60063-DS Instruction Manual
Remarks:
① The location of adding water
② Water flow out location
③ Back door for electrical wire & pump pass through
Process:
- Place the fountain on the ground.
- Pull out the PVC tube from location
③
，
then connect
with the pump, showed as photo ⑤
- Pull out the cable line of light and pump from location ③,
and Connect the cable of light with the adaptor,
showed as photo ⑤
- Add clean water on location ①, adjust the flow control of the pump ,
show as ④,close the back cover ,showed as photo ③
, showed as & ⑤
- Processing the plug of pump and adaptor into the circuit,
then after a short while, the water would flow out from the
location
②
Caution:
The pump must be fully submerged in the water to operate
properly and prevent pump & humidifier from overheating.