Specification

Owners Manual
Version 3
Temp Up
Increase Temperature
Temp Down
Decrease Temperature
Select/Light
Enter & Lights On/Off
Jets 3/Blowers
Activates Jets 3/Blower
Jets 1
Activates Jet 1
Jets 2
Activates Jet 2
For Tub Models:
• Alberta • Niagara • Vancouver
• St. Lawrence 13’
Configuration: Your Control Centre
FLIP (INVERT DISPLAY)
Press the dedicated Flip/Invert button
Allows the user to flip the display with a single button press.
BUTTON FUNCTIONS
ADJUST TEMPERATURE
When using a panel with Up and Down buttons (Temperature
buttons), pressing Up or Down will cause the temperature to flash.
Pressing a temperature button again will adjust the set temperature
in the direction indicated on the button. When the LCD stops flashing,
the spa will heat to the new set temperature when required. The
temperature can be set between 60°F (15 °C) and 104°F (40 °C).
PRESS-AND-HOLD
If a Temperature button is pressed and held when the temperature is
flashing, the temperature will continue to change until the button is
released.
TEMPERATURE UP
TEMPERATURE DOWN
PRESS TO CHANGE LIGHT SETTINGS
LIGHTS
Press light button to turn on and off the lights. Each consecutive press
will alternate through different lighting modes and colours.
JETS
Press the “Jets 1” button once to turn pump 1 on or off, and to shift
between low- and high-speeds. If left running, the pump will turn off
after a time-out period. The pump 1 low-speed will time out after 30
minutes. The high-speed will time out after 15 minutes.
The low-speed of pump 1 runs when the blower or any other pump
is on. If the spa is in Ready Mode Pump 1 low may also activate for
at least 1 minute every 30 minutes to detect the spa temperature
(polling) and then to heat to the set temperature if needed. When the
low-speed turns on automatically, it cannot be deactivated from the
panel, however the high speed may be started.
JETS 1, JETS 2, JETS 3