User's Manual
. Please insert the mini USB receiver / dongle into the available USB port.
Inserting Batteries
Mouse:
. Simply open the mouse battery lid, which is located on bottom
surface of the mouse.
. Insert 2 triple A rechargeable batteries into the battery tray. Please
make sure that the batteries were inserted correctly before closing
the battery lid.
Keyboard:
. Simply open the keyboard battery lid, which is located on backside
of the keyboard.
. Insert 2 triple A batteries into the battery tray. Please make sure
that the batteries were inserted correctly before closing the battery
lid.
Connection Setup
Mouse:
. Simply press the LED/connect button on the mini USB receiver
dongle.
. Then, press the connect button on the bottom surface of the
mouse to establish the wireless connection.
Keyboard:
. Simply press the LED/ connect button on the mini USB receiver
dongle.
. Then press the connect button on top surface of the keyboard to
establish the wireless connection.
Test the Mouse
. Simply move around the mouse. If the LED on the mini receiver flashes while
moving the device, the connection has been established successfully. Otherwise,
the connection has been failed to establish. Please retry the connection setup
step if the connection has been failed to establish.
Charge the Mouse
. The device uses Ni-MH rechargeable batteries. Therefore please charge the
device for at least 8 hours prior to the first time use to avoid power leaking. To
charge the mouse, please plug in the connector of pin point cable into the front
end of the mouse, and plug in the other side of the connector to the side of the
mini receiver. You may unplug the cable when the charging signal on the mini
receiver switches off.
Attention: The device should be charged when the mouse cursor is not moving
smoothly and the device is used in proper distance.
Test the Keyboard