Installation guide

Page 38 of 51
172
DHW temperature was invalid
173
DHW inlet temperature was invalid
174
DHW outlet temperature was invalid
175
DHW high limit must be disabled for Auto mode
176
DHW sensor type was not compatible for Auto mode
177
DHW priority source setting was invalid
178
DHW priority method setting was invalid
179
CH S5 (J8
-
11) sensor was invalid
180
CH Inlet temperature was invalid
181
CH S10 (J10
-
7) sensor was invalid
182
Lead Lag CH setpoint source was invalid
183
L
ead Lag P
-
gain was invalid
184
Lead Lag I
-
gain was invalid
185
Lead Lag D
-
gain was invalid
186
Lead Lag OFF hysteresis was invalid
187
Lead Lag ON hysteresis was invalid
188
Lead Lag slave enable was invalid
189
Lead Lag hysteresis step time was inva
lid
190
No Lead Lag Modbus port was assigned
191
Lead Lag base load common setting was invalid
192
Lead Lag DHW demand switch setting was invalid
193
Lead Lag Mix demand switch setting was invalid
194
Lead Lag modulation sensor setting was invalid
19
5
Lead Lag backup modulation sensor setting was invalid
196
Lead Lag slave mode setting was invalid
197
Lead Lag rate allocation setting was invalid
198
Lead selection setting was invalid
199
Lag selection setting was invalid
200
Lead Lag slave return
setting was invalid
201
Lead Lag add stage method setting was invalid
202
STAT may not be a Lead Lag CH demand source when Remote Stat is enabled
203
Lead Lag base load rate setting was invalid
204
Lead Lag master was suspended due to fault
205
Lead
Lag slave was suspended due to fault
206
Lead Lag header temperature was invalid
207
Lead Lag was suspended due to no enabled Program Module installed
208
Lead Lag slave session has timed out
209
Too many Lead Lag slaves were detected
210
Lead Lag sla
ve was discovered
211
Incompatible Lead Lag slave was discovered
212
No base load rate was set for Lead Lag slave
213
Lead Lag slave unable to fire before demand to fire delay expired
214
Adding Lead Lag slave aborted due to add requirement change
215
No Lead Lag slaves available to service demand
216
No Lead Lag active service was set due to demand priority conflicts
217
No Lead Lag add stage method was specified
218
No Lead Lag drop stage method was specified
219
Using backup Lead Lag header sens
or due to sensor failure
220
Lead Lag frost protection rate was invalid
221
Lead Lag drop stage method setting was invalid