Installation guide

Page 3 of 51
1.1 Bacnet/LONWorks/Metasys N2Setup through Protocessor Protonode
RER/LER
Installation steps for the customer
1. Record the information about the unit See Section
2. Set the DIP switches
3. Connect up the Field and Host cable
4. Connect the power
1.2 Protonode RER and LER showing connection ports
Figure 1: Protonode Bacnet/ Metasys N2 RER (left) and Lonworks (LER)
1.3 Record Identification Data
Each ProtoNode has a unique part number located on the underside of the unit. The
number format is FPC-N3(4,5)-XXX-XXX-XXXX. This number should be recorded as it may
be required for technical support.