Installation guide

Page 2 of 51
DynaFlame/DynaForce SOLA and BMS Protocols
Table of Contents
1.1 Bacnet/LONWorks/Metasys N2Setup through Protocessor Protonode RER/LER .............. 3
1.2 Protonode RER and LER showing connection ports .......................................................... 3
1.3 Record Identification Data ............................................................................................... 3
1.5 Connection from DynaFlame/DynaForce to ProtoNode ................................................... 7
1.6 Connection from ProtoNode RER to BMS ......................................................................... 7
1.7 Power Up the Device ....................................................................................................... 8
1.8 Install and Run the Utility Software .................................................................................. 8
1.10 Connect to the ProtoNode using RUI (Ruinet) ................................................................ 10
1.11 Troubleshooting Tips ..................................................................................................... 12
1.12 ProtoNode Specifications ............................................................................................... 14
LonWorks Protocol Gateway ............................................................................................. 16
ProtoCarrier 485 (FPC-CD2) .............................................................................................. 17
RS-485 Signal LEDs ............................................................................................................ 17
2.1 Modbus ......................................................................................................................... 17
2.2 Bacnet, Modbus and Metasys N2 Registers .................................................................... 18
2.3 Lockout Codes ............................................................................................................... 30
2.4 PII, LCI, ILK Terminal Configuration ................................................................................ 34
2.5 SOLA Alert Codes ........................................................................................................... 34
Appendix A................................................................................................................................ 45